A .001 kg bead slides without friction around a loop-the-loop. The bead is released from a height of 20.6 m from the bottom of the loop-the-loop which has a radius 7 m. The acceleration of gravity is 9.8 m/s [photo] What is its speed at point A ? Answer in units of m/s. Your answer must be within ± 5.0%

Answer:

During a star-studded but socially safe ceremony for the 10th Annual NFL Honors, Green Bay Packers quarterback Aaron Rodgers earned the prestige of being the 2020 NFL Most Valuable Player (MVP).

Answer:

The current would increase.

Explanation:

The current would increase. 10. The relationship between resistance and current in a circuit is that the greater the resistance the less the current and the greater the current the less the resistance is.

if a 1.5-volt battery is removed and placed by a 9-volt battery in a circuit, From Ohm's law we can say that the current flow inside the circuit will increase because the voltage increases (resistance remains constant).

Ohm's Law is a fundamental law of physics that describes the relationship between the three basic electrical quantities: voltage, current, and resistance in a circuit.

It states that the current through a conductor between two points is directly proportional to the voltage across the two points and inversely proportional to the resistance between them. Mathematically, Ohm's Law is expressed as:

V = I x R

Where:

V = the voltage or potential difference between two points in the circuit,       measured in volts (V).

I = the current flowing through the circuit, measured in amperes (A).

R = the resistance of the conductor, measured in ohms (Ω).

In other words, the voltage (V) across a circuit component is equal to the product of the current (I) flowing through the component and its resistance (R). This law is applicable to both DC (direct current) and AC (alternating current) circuits, as long as the resistance is constant.

Ohm's Law can be used to calculate any one of the three variables if the other two are known. For example, if the voltage and resistance in a circuit are known, the current flowing through the circuit can be calculated using the formula:

I = V / R

Here in the question,

The current in a circuit is determined by the resistance of the circuit and the voltage applied to it, according to Ohm's Law. If a 9-volt battery replaces a 1.5-volt battery, the voltage applied to the circuit will increase, which may cause an increase in the current flowing through the circuit if the resistance remains the same.

However, the increase in voltage may also cause an increase in the heat generated by the circuit, which could potentially damage the components or cause a safety hazard. Therefore, it is important to ensure that the components in the circuit can handle the higher voltage before replacing the battery.

It's also important to note that the current may also depend on the internal resistance of the batteries. A 9-volt battery typically has a lower internal resistance than a 1.5-volt battery, which means it can supply more current to the circuit. So, even if the resistance of the circuit remains the same, the current may still increase due to the higher voltage and lower internal resistance of the 9-volt battery.

Hence, The current flowing through the circuit increased when we removed a 1.5-volt battery and replaced it with a 9-volt battery.

To learn more about Ohm's Law click:

https://brainly.com/question/1247379

#SPJ2

Answer:

27 J

Explanation:

Answer:

1.876 J

Explanation:

First, let’s calculate the compression of the spring from the Hooke’s law:

F=kx,

here, F=75 N is the force acted on the spring, k=1500 N⁄m is the force constant of the spring, x is the compression of the spring.

Then, we get:

x=F/k=(75 N)/(1500 N/m)=0.05 m.

Finally, we can find the potential energy stored in the spring:

PE=1/2 kx^2=1/2∙1500 N/m∙(0.05 m)^2=1.875 J.

correct my answer if it's wrong ^^

Answer:

The average impact force is 12000 newtons.

Explanation:

By Impact Theorem we know that impact done by the sledge hammer on the chisel is equal to the change in the linear momentum of the former. The mathematical model that represents the situation is now described:

[tex]\bar F \cdot \Delta t = m \cdot (v_{2}-v_{1})[/tex] (1)

Where:

[tex]\bar F[/tex] - Average impact force, in newtons.

[tex]\Delta t[/tex] - Duration of the impact, in seconds.

[tex]m[/tex] - Mass of the sledge hammer, in kilograms.

[tex]v_{1}[/tex], [tex]v_{2}[/tex] - Initial and final velocity, in meters per second.

If we know that [tex]\Delta t = 0.0020\,s[/tex], [tex]m = 4\,kg[/tex], [tex]v_{1} = -6\,\frac{m}{s}[/tex] and [tex]v_{2} = 0\,\frac{m}{s}[/tex], then we estimate the average impact force is:

[tex]\bar F = \frac{m\cdot (v_{2}-v_{1})}{\Delta t}[/tex]

[tex]\bar F = 12000\,N[/tex]

The average impact force is 12000 newtons.

Answer:

6.67×10¯⁹ A

Explanation:

From the question given above, the following data were obtained:

Quantity of electricity (Q) = 2 μC

Time (t) = 5 mins

Current (I) =?

Next, we shall convert 2 μC to C. This can be obtained as follow:

1 μC = 1×10¯⁶ C

Therefore,

2 μC = 2 μC × 1×10¯⁶ C / 1 μC

2 μC = 2×10¯⁶ C

Next, we shall convert 5 mins to seconds. This can be obtained as follow:

1 min = 60 secs

Therefore,

5 min = 5 min × 60 sec / 1 min

5 mins = 300 s

Finally, we shall determine the current in the circuit. This can be obtained as follow:

Quantity of electricity (Q) = 2×10¯⁶ C

Time (t) = 300 s

Current (I) =?

Q = It

2×10¯⁶ = I × 300

Divide both side by 300

I = 2×10¯⁶ / 300

I = 6.67×10¯⁹ A

Thus, the current in the circuit is 6.67×10¯⁹ A

Answer:

The second (abbreviation, s or sec) is the Standard International ( SI ) unit of time. One second is the time that elapses during 9,192,631,770 (9.192631770 x 10 9 ) cycles of the radiation produced by the transition between two levels of the cesium 133 atom. ... One second is equal to 1/86,400 of a mean solar day.

Explanation:

the answer is 165J

1/2×3.9×(9.2)^2 = 165J

Answer:

true

Explanation:

if all forces are equal then there would be no stronger force to give any net force so it would be zero

Answer: Neap tides

Explanation: Neap tides are tides that have the smallest tidal range, and they occur when the Earth the Moon, and the Sun form a 90o angle. They occur exactly halfway between the spring tides when the Moon is at first or last quarter.

Answer:

A. 12,240.

Explanation:

1,530 times 8.0 = 12,240.

hope this helped :)

Answer:

the coefficient of friction

Answer:

Once you've had chickenpox you can't again.

Explanation: the virus remains inactive in your nerve tissue. Although it's unlikely you will get chickenpox again, the virus may reactivate later in life and cause a related condition called shingles.

Answer:

1000 m

Explanation:

Given that,

The frequency of radio waves f = 300,000 Hz

We need to find the wavelength of these waves.

The formula to find wavelength is as follows :

[tex]c=f\lambda\\\\\lambda=\dfrac{c}{f}\\\\\lambda=\dfrac{3\times 10^8}{300000}\\\\\lambda=1000\ m[/tex]

So, the wavelength of these waves is 1000 m.

Answer:

its the last question

Explanation:

Thats because erosion takes away stuff

Answer:

Displacement (km)

Explanation:

The y axis is the vertical axis pointing up and down. This is labeled as the the displacement (km) in the graph.

Explanation:

Wave speed  =  (frequency)  x  (wavelength)

                      =  (266 /sec)  x  (1.3 meters)

Answer:

B. [tex]\frac{218}{85} At[/tex]

Explanation:

A P E X

The nucleus that completes the following equation is ²²⁶Ac₈₉

²²²Fr₈₇ →⁴He₂ +  ²²⁶Ac₈₉

Therefore the correct answer is option C.

The phenomenon of Radioactive decay is a type of nuclear reaction in which the unstable nucleus of a radioactive element lose energy in the form of nuclear radiation, some examples of radioactive decay are alpha decay, decay, and beta decay.

The complete equation for the nuclear reaction is

²²²Fr₈₇ →⁴He₂ +  ²²⁶Ac₈₉

For the given problem the nucleus completes the given equation is  ²²⁶Ac₈₉. The correct answer is option C.

learn more about radioactive decay

brainly.com/question/1770619

#SPJ2

Answer:

The radius will be "100.31 m". A further solving is given below.

Explanation:

The given values are:

Time,

T = 2 minutes

i.e.,

 = 120 seconds

Speed,

V = 5.25 m/s

As we know

⇒  [tex]T=\frac{2 \pi R}{V}[/tex]

then,

⇒  [tex]R=\frac{TV}{2 \pi}[/tex]

On substituting the given values, we get

⇒      [tex]=\frac{120\times 5.25}{2\times 3.14}[/tex]

⇒      [tex]=\frac{630}{6.28}[/tex]

⇒      [tex]=100.31 \ m[/tex]

Answer:

fire

Explanation:

burning the the oil

Answer:

Yes

Explanation:

tamad ako magexplain

Answer:

Yes

Explanation:

The force exerted by a magnet is called

The push or pull of magnetism

can act at a distance, which means that the

magnet does not have to touch an object

to exert a force on it. When you close the

refrigerator, you feel the pull before the

magnet actually touches the metal frame.

There are other forces that act at a distance,

including gravity and static electricity. Later

you will read how the force of magnetism is

related to electricity. In fact, magnetism is

the result of a moving electric charge.

Answer:

Flask 1

Explanation:

when volume goes down pressure goes up, and the first flask has the smallest volume therefore the greatest pressure

We have that from the ideal gas equation that the flask with the lowest volume will have the highest pressure therefore

Flask one has the lowest Pressure

Option D

From the question we are told

Each of these flasks contains the same number of gas molecules. In

which container is the pressure highest

Generally the equation for an Ideal gas given as   is mathematically given as

The ideal gass equation

[tex]PV=nRT[/tex]

Where

P=pressure

V=Volume

n=No of mole

R=Gas Constant

T=temperature

Therefore We have that from the ideal gas equation that the flask with the lowest volume will have the highest pressure therefore

Flask one has the lowest Pressure

For more information on this visit

https://brainly.com/question/13338592?referrer=searchResults

Answer:

The average speed for the runner B for the first 25 seconds was;

30/25 = 1.2 m/s

Explanation:

The average speed of an object is given by the following formula

[tex]Average \ speed = \dfrac{Total \ distance \ covered}{Total \ time \ taken \ to \ cover \ the \ distance}[/tex]

From the graph, we have;

The coordinates of the runner B at the start = (0, 0)

The coordinates of the runner B after 25 seconds = (25, 30)

The total distance covered by the runner B after 25 seconds = The difference between the position at 25 seconds and the origin which is 30 meters

∴ The total distance covered by the runner B after 25 seconds = 30 meters

The time it takes the runner B to cover the distance = The 25 seconds

[tex]\therefore \ For \ the \ runner \ B, the \ average \ speed = \dfrac{30 \ meters}{25 \ seconds} = 1.2 \ m/s[/tex]

The average speed for the runner B for the first 25 seconds = 30 m/(25 s) = 1.2 m/s.

Answer:

please give me brainlist and follow

Explanation:

topographic map

A topographic map shows a three-dimensional representation of a flat surface. It has contour lines joining points of equal elevation; the closer the lines are the steeper the elevation is.

Answer:

hi

Explanation:

as a result of the collision of hot and cold air

hope it helps

have a nice day

Answer:

Hey mate.....

Explanation:

This is ur answer.....

Wind is the movement of air caused by the uneven heating of the Earth by the sun. ... Warm equatorial air rises higher into the atmosphere and migrates toward the poles. This is a low-pressure system. At the same time, cooler, denser air moves over Earth's surface toward the Equator to replace the heated air.

Hope it helps!

Brainliest pls!

Follow me! :)