What does the 5, W, and 30 mean in oil that has a viscosity rating of 5W- 30
Answer:
The short answer:The numbers represent the viscosity of the oil and the W stands for WINTER. ... In a 5W-30 for example, the number before the W describes the viscosity of the oil at low temperatures. The lower the number, the thinner the oil and the better the oil's cold temperature/ cold start performance.
How much paint would you need to cover one bedroom wall using 2 coats of paint?
•Wall: 18 feet x 15 feet
•Research how much paint one gallon will cover
•Show your calculations
•Answer must be in gallons
Answer:
One gallon of paint can cover about 400 square feet of wall.
18 x 15 feet is 270 feet of space.
270/400 = .675 gallons for one coat on one wall
.675 x 4 = 2.7 gallons for one coat on all walls
2.7 gallons x 2 = 5.4 gallons of paint in all
best budget freestyle drone?
Hx115 it's pretty fine looking
HELP! What are 5 changes that a fidget spinner can be?
Answer:
Uh- a fidget spinner can be... a fidget?
Explanation:
Unless you're talking about chemical changes, then a fidget cannot change forms <33
Need help, I will give cake :))
+ branliest
Answer:
A
Explanation:
it goes good with it.
What happens to the value of most vehicles over time?
They decrease in value
They increase in value
The value stays the same
All the above
Need help, I will give a cookie to correct answer.
-( branliest)-
Which of the following personnel is required in an ALS emergency medical unit?
A.) firefighter
B.) EMT
C.) lieutenant
D.) paramedic
ANSWER: D
Answer:
D
Explanation:
Click this link to view O*NET’s Work Styles section for Accountants. Note that common work styles are listed toward the top and less common work styles are listed toward the bottom. According to O*NET, what are some common work styles needed by Accountants? Select four options
trust
dependability
creativity
attention to detail
integrity
analytical thinking
Answer:
dependability
attention to detail
integrity
analytical thinking
Explanation:
According to de O*NET the most common work styles need is dependability, attention to detail, integrity and analytical thinking.
What are the work styles?There are four basic styles of work: execution, leadership, lovers and learning. Each professional has their specific characteristics, and it is up to the boss to identify them and use them in the best way. The best teams have a balance between the four styles
In this case according to the O*NET the most famous work styles are:
dependability, attention to detail, integrityanalytical thinking.See more about work at brainly.com/question/756198
1. Give an example of how a 3D solid computer
model could be used in each step of the design
process and the purpose each model would serve.
Answer:
It means that every dimension, relation, feature, and step defining the model is shown on history-based management. This lets you reflect your design intent on a quickly editable interface, meaning plenty of space for customization and design freedom and your concept’s progress.
Explanation:
3D solid computer model is vital to the design process as it gives the design an editable interface and a simplified process.
Solid modeling refers to the computer modeling of the 3D solid objects. The importance of solid modeling is that it's vital in ensuring that the surface is geometrically correct. Through solid modeling, the user can be able to design and create digital 3D models.It should be noted that when the user is able to visualize the design in 3D, this will give the person an idea about how the finished project will be. With 3D computer modeling, the design process becomes simplified. One gets a better quality at a reduced cost.Read related link on:
https://brainly.com/question/17994947
Pedro holds a heavy science book over his head for 10 minutes. Petro is doing work during that time. True or False
Answer:
True because he is working his arms to lift and hold the weight
Explanation:
To revise a monthly budget, changes in which categories might need to be addressed? Check all that apply.
Income
amount budgeted
expenses
where will a power cable most likely fail
A.at the connection to the plug
B.at a crimp
C.at the connection to the molded receptacle to the cable
D.at the connection to the load at the terminal
Answer:
A cable failure almost always exhibits itself as either an open circuit or a short circuit. Open circuits are more common in low voltage cables than at medium or high voltage. Open circuits are usually the result of failed connectors, or broken and/or corroded conductors.
Direction: List down or enumerate the type of outlets you want to install on your dream house. Also indicate the quantity (in piece/s) of your outlets. Give at least two in every area of the house.
Living Room
1. (Example) Duplex Convenience Outlet – 4pcs.
2.
Bed Room
3.
4.
Kitchen
5.
6.
Garage
7.
8.
Garden or Outside of your house
9.
10.
Answer:
Apartment outlet 4pcs
Explanation:
From the article "Time Travel Is A Fun Science Fiction Story But Could It Be Real?", Albert Einstein's Theory of Relativity is described as what?
Question 3 options:
The pulling force of gravity causes space to curve and causes time to slow down.
Everything is relative to where you are on only Earth.
Space and time are different things
Einstein never thought of the Theory of Relativity
Answer:
Option A
Explanation:
As per the article "Time Travel Is A Fun Science Fiction Story But Could It Be Real?" the gravitational field is a representation of curving space and time. As the gravity becomes strong, the space-time get more curved and hence the time gets slower.
Hence, option A is correct
Answer:
The pulling force of gravity causes space to curve and causes time to slow down.
Explanation:
Hope this helps!
A(n)
is a safety device commonly
used with a slotted nut.
A safety device called a cotter pin. The cotter pin fits through a hole in the bolt or part. This keeps the nut from turning and possibly coming off.
What have you learned about designing solutions? How does this apply to engineering? Think of some engineering solutions that started with a simple problem, and write them down
Answer:
In engineering design, failure is expected. It helps you find the best solutions before implementing them in the “real world”. Having a prototype fail is a GOOD thing, because that means you have learned something new about the problem and potential solutions.
Explanation:
what is the research and development process in order?
It is a cross functional process that includes market research, technical research, design of a concept, prototype creation, final product creation and launch.
Why is the Type 3 engine most likely to be found in rural areas?
A.) Rural areas are more likely to have open fields, farmland, and forest areas that would require the apparatus.
B.) Rural areas have larger budget allowances, so they can purchase more specialized apparatuses.
C.) Urban areas experience large enough fires to require the need for more than one apparatus.
D.) Urban areas have equipment that serves the same purpose, so there is no need for another apparatus.
ANSWER: A
1 point
The figure below shows a nail gun. Which principle explains how this
works?
O Pascal's principle
O Bernoulli's principle
O Archimede's principle
O Principle of momentum conservation
I think the orange thing on the gun but i dont know what principle it is but i think its c
Explanation:
Whem you press the orange thing it starts to work
How old are you in dog years and
Answer:
It depends but on average I am 86 years old (I'm 14)
Explanation:
sorry here is my second one
Answer:
brainlyest if it right and sorry if it was wrong
Explanation:
1:a
2:b
3:a
4:a
5:c
6:a
Why do engineers need to be particularly aware of the impact of hubris?
A) Their creations change society.
B) They are most responsible for individuals' physical health.
A) Their creations change society.