Bijan wanted to find the density of a piece of metal. He weighed it. Them he measured its volume by placing it in measuring cylinder which was half-full of water. Here are his measurements: Mass of metal - 196.0 g, reading on measuring cylinder (water only) = 45 cm3 and reading on measuring cylinder (water + metal) = 68 cm3. What is the density of the piece of metal?

Answer:

5235.84 kg

Explanation:

There is one theorem - whose proof I will never remember without having to drag calculus in there - that says that the variation of momentum is equal to the force applied times the time the application last.

[tex]F\Delta t = m \Delta v[/tex] As long as the engine isn't ejecting mass - at this point it's a whole new can of worm - we know the force, we know the variation in speed, time to find the mass. But first, let's convert the variation of speed in meters per second. The ship gains 250 kmh, [tex]\Delta v = 69.4 m/s[/tex];

[tex]45 450 \cdot 8 = 69.4 m \rightarrow m = \frac{45450\cdot 8}{69.4} = 5235.84 kg[/tex]

Answer:

Only part of the incident energy from an X-ray source may be used by the ejected electron (some of the energy can be used by the exiting photo electron and some of the energy by the exiting photon).

Auger electrons depend on the energy difference between energy levels of an atom and are fixed - so the ejected electron will have a fixed energy depending on the difference of energy levels of the atom. The Auger effect is called a "radiationless" transition because no radiation is detected outside of the atom.

Answer:

LOL Diagrams

a way to represent how the energy is stored in the chosen system during various snapshots and to represent any changes in total energy for the system. Each “L” represents how the energy is stored during a particular snapshot (instant). The “O” shows the objects inside and outside the system.

Answer:

Atmospheric pressure is caused by the gravitational attraction of the planet on the atmospheric gases above the surface and is a function of the mass of the planet, the radius of the surface, and the amount and composition of the gases and their vertical distribution in the atmosphere

Explanation:

Answer:

Speed: 109.4–120.7 km/h (68.0–75.0 mph)

Strength: Couldn't find out.

Explanation:

Answer:

(a) 6,000,000J      

(b)  3,000,000J

(c)  For A 20,000W

But for B 10,000W

The work done in getting  the car to the top is equal to 6 ×10⁶ J. If the vertical speed is 2.5 m/s then, the work done will be  3 ×10⁶ J. The power exerted on the car is in 5 minutes is 20000 J/s.

In physics, work done is the dot  product of force and displacement. Let w be the work done and F and ds be the force and displacement. Then

W = F.ds

It is given that the, the force of the cable is 4 × 10³ N. The velocity is 5 m/s and time is 5 minutes or 300 seconds. Now, the displacement is the product of time and velocity.

ds = velocity ×  time

    =  300 s ×  5 m/s

    = 1500 m.

Thus the work done = F × ds

                                  = 4 × 10³ N ×  1500 m

                                  = 6 ×10⁶ J .

If the velocity is reduced to half 2.5 m/s , then work done will be reduced to half as 3 ×10⁶ J.

Power is the rate of work done. Thus it is the ratio of work done to time. The power exerted on the car in 5 minutes = 6 ×10⁶ J /300s

                                                                        = 20000 J/s

Hence, the power exerted on the cable car in 5 minutes is 20000 J/s.

To find more on work done, refer here:

https://brainly.com/question/3902440

#SPJ3

Answer:

Known variously as the Newcomb–Benford law, the law of anomalous numbers, or the first-digit law, Benford's Law is the observation that the first digit in many real-world collections of numerical data will be tiny, as shown by the example of the first-digit law.

Explanation:

Hope it helps:)

Answer:

The uneven heating results in some of the atmosphere to be warmer than other parts and changes in volume and pressure which result in updrafts and can cause thunderstorms and other violent weather.

Explanation:

Generation of wind

Answer:

116 N•s

Explanation:

change in momentum = mvf-mvi

= m(Vf - Vi)

= 20( 8.1-2.3)

change in momentum= 116 kg•m/s

: .impulse is 116 N•s

Answer:

All objects are composed of these atoms. ... Charged objects have an imbalance of charge - either more negative electrons than positive protons or vice versa. And neutral objects have a balance of charge - equal numbers of protons and electrons.

Explanation:

Answer:

Seismometer

Explanation:

Seismometer measures Earth quake epicenter while seismograph measures Earth quake size

Answer:

I can't see the picture, can you right down the same thing that is the picture in the comments so I can help you.

Explanation:

Thx.

Answer: -2m/s²

Explanation:

Each second, the acceleration decreases of 2m/s²

N.B.: in physics, deceleration is also acceleration.

Answer: yess sirrrrrrrr

Explanation:

Answer:

oou I like it! u did a good job ^^

Answer:

C.

Explanation:

Answer:

c. Radio and T.V. signals

Answer:

velocity ,V=?,T=4hr,Distance ,144km,

V=distance divide by time

=144/4=36km/hr

Answer:

The greater the amplitude of a wave then the more energy it is carrying.

Explanation:

E is carrying the most energy which means that it has the highest amplitude

A has the least energy because it has the lowest amplitude

Answer:

willie tower

Explanation:

mataas kasi

Explanation:

Spring is stretched by force f to distance

"X"

now here by force balance we can say

f = kx

k = !

now here we will we say that energy stored in the spring will convert into kinetic energy

kx² = mv²

(x² = mv²

now solving above equation we will have

PART 2)

now for half of the extension again we can use energy conservation

ka²-k(x/2)² = 1 {mv²

¾fx=mv²

now the speed is given as

3 fr 4m V=

Answer: 4.44302176697 m/s^2

Explanation:

formula for acceleration is (final velocity - initial velocity)/time.   So in your case:

(34.7m/s - 0m/s)/ 7.81s  = 4.44302176697 m/s^2

The magnetic field strength is needed to generate a peak voltage 0.15 T.

The given parameters;

The area of the coil is calculated as follows;

[tex]A = \pi r^2\\\\A = \pi \times 0.09^2\\\\A = 0.0255 \ m^2[/tex]

The maximum emf induced in the coil is calculated as follows;

[tex]E_{max} = NBA \omega \\\\B = \frac{E_{max}}{NA\omega } \\\\[/tex]

where;

[tex]B = \frac{170 }{120 \times 0.025 \times 2\pi \times 60 } \\\\B = 0.15 \ T[/tex]

Thus, the magnetic field strength is needed to generate a peak voltage 0.15 T.

"Your question is not complete, it seems to be missing the following information";

An electric generator has an 18-cm-diameter, 120-turn coil that rotates at 60 hz in a uniform magnetic field that is perpendicular to the rotation axis.

What magnetic field strength is needed to generate a peak voltage of 170 V?

Learn more here:https://brainly.com/question/17238887

The 4th state of matter would make an acceptable force field.

The 4th state of matter which is plasma would make an acceptable force field because this fourth state of matter is present in ionized form which has two charges on it i.e. cation which is a positive charge and anion which is a negative charge.

We know that charges attract as well repel other objects if they are strong enough. Positive charge repel positive charge but attract negative charge so we can conclude that 4th state of matter would make an acceptable force field.

Learn more: https://brainly.com/question/25628398

Explanation:

The rod can be in equilibrium only if the resultant force is 0 and the moment around any point of the rod must be equal to 0.

We have to take moments around the pivoted point.

Moment = Force × Perpendicular distance to the force

For the rod to be in equilibrium,

Clockwise moment - Anticlockwise moment = 0

Clockwise moment = Anticlockwise moment

The distance between pivoted point and the weight of rod = 50 cm - 30 cm = 20 cm

So 20 cm× 1.2 N produces a Clockwise moment

If Perpendicular distance between pivoted point and 2N load is x,

Anticlockwise moment = x × 2N

20 cm× 1.2N = 2N × x

x = 12 cm

So 2 N load is at 12 from the pivoted point.

From the left edge of the meter ruler, 2N load is at 30-12 cm distance

= 18 cm

Answer: 18 cm

Explanation:

Answer:

Photons

Explanation:

I just know

Discrete packets of kinetic energy in light are called photons. Photons are fundamental particles of light and electromagnetic radiation. The correct answer is photons.

Photons are fundamental particles of light and electromagnetic radiation. They carry energy in discrete quantities, known as quanta or packets, and exhibit both wave-like and particle-like properties.

The energy of a photon is directly proportional to its frequency, and inversely proportional to its wavelength. When light interacts with matter, it can transfer its energy to the particles it interacts with, leading to various phenomena such as absorption, reflection, and emission.

Therefore, Discrete packets of kinetic energy in light are called photons.

To know more about the photon:

https://brainly.com/question/34096290

#SPJ6

Answer: G

Explanation:

Answer:

a) F = 84.64N

b) The force has to increase.

Explanation:

First of all, let's convert everything to the same unit system:

Vo = 0 m/s    Vf = 98 mi/h * 1609.34 m / 1mi * 1h / 3600s = 43.8m/s

d = 1.7m         m = 0.15kg

We can calculate force as:

F = m*a    where a is the acceleration experiencd by the ball and m is its mass.

In order to calculate acceleration, we can use this formula:

   Solving for a:

Now, the force will be:

F = m * a = 84.6N

As we can see in that previous equation, the force is directly proportional to the mass of the ball, so, assuming the final speed of the ball is the same as before (that is, the acceleration is the same), the force will increase in the same proportion as the mass does.