Define the following:
Variable
Data
Control
Technology
Hypothesis
Physical Science
Experiments

Answer:

Point A

Explanation:

Point C is way to close to where the force would need to be.

Point B is close but not as close, the reasonable answer would be point A.

Marianne’s father should place the small rock: he should place the rock (fulcrum) close to the boulder (at Point A).

The simplest devices, like levers, are employed to complete tasks quickly. Leverage is the ability to increase an input force to produce a stronger output force. We are known that there are different kinds of levers depending on the force, weight, and fulcrum point. Each tool that is used to complete a task falls into one of these categories.

One of the six simple devices that Renaissance scientists identified. Leverage is the ability to increase an input force to produce a stronger output force.  The mechanical advantage of the lever is determined by the ratio of output force to input force.

Learn more about lever here:

https://brainly.com/question/18128414

#SPJ2

Answer:

This air being forced out causing the air pressure inside to be much lower than that on the outside. As higher air pressure always pushes, it keeps the two plungers together.

Hope that helps. x

Answer:

try 2.4136 as an answer/ good luck

The perimeter of ΔWXY is : ( D ) 14.5 cm

Calculating the perimeter of ΔWXY

QR = WY / 2

RS = XW / 2

QS = XY / 2

Given that : QR = 2.93 cm ,  RS = 2.04 cm,  QS = 2.28 cm

Therefore

Perimeter of ΔWXY = ∑ WY + XW + XY  

                                 = 2SR + 2QS + 2QR

                                 = 2(2.04) + 2(2.28) + 2(2.93)

                                 = 14.5 cm

Hence we can conclude that the perimeter of ΔWXY = 14.5 cm

learn more about perimeter calculations : https://brainly.com/question/24744445

Answer:

The name of the shape on the right is M prime N prime O prime P prime Q prime R prime S prime because it is the image of the shape on the left.

Explanation:

The relation of the kinetic energy allows to find the correct result for the energy stored in the electromagnet is:

B) 283 MJ

Kinetic energy is the energy due to the movement of bodies.

          K = ½ m v²

Where K is the kinetic energy, m is  the mass and v the spped.

They indicate that the weight of the bodye is W = 981 N and its final velocity is v = 7 [tex]v_s[/tex].

          W = m g

Since the projectile starts from rest, its initial velocity is zero, therefore the change in energy is

        ΔK = [tex]K_f - K_o = K_f[/tex]  

we substitute

        ΔK = ½ 981 / 9.8 (7 340) ²

         ΔK = 2.835 10⁸ J

They indicate that all the energy of the electromagnet is transformed into the energy of the projectile,

          Em = K

When reviewing the results, the correct one is:

       B) 283 MJ

In conclusion, using the relationship of kinetic energy we can find the correct result for the energy stored in the electromagnet is:

   B)  283 MJ

learn more about kinetic energy here: brainly.com/question/8101588

Answer:

when it is released the reading will be zero because gravitational force acts on it you can also say as free fall body

Explanation:

Answer:

the volume changes overtime

sometimes because of weather, temperature ...

Explanation:

When traveling with average speed 40 km/h, the car would cover a distance of 80 km in time t such that

40 km/h = (80 km) / t   ⇒   t = 2 h

so the total travel time is 2 h + 3 h = 5 h.

Average speed is defined as the total distance traveled divided by the time it took to cover that distance. So if the overall average speed was 30 km/h, then

30 km/h = (80 km + x) / (5 h)   ⇒   x = 70 km

where x is the distance traveled in the last 3 h of the trip.

Then the total displacement of the car is 80 km + 70 km = 150 km.

Newton's second law and the kinematic relations allow to find the results for the questions about forces and the movement of the block are:

    B) the force applied to maintain the system is equilibrium is: F = 0.39 N with an angle of tea = 180º

    C) The maximum force is: F = 24 N

    D) The time to stop the block is: t = 25 s

Newton's second law establishes a relationship between the net force, the mass, and the acceleration of the body. In the special case that the acceleration is zero it is called the equilibrium condition.

B) They indicate a diagram of forces on the block, let's look for the components of the force that the block maintains with zero acceleration, in the attached we have a free-body diagram including the force applied to keep the system in equilibrium.

x-axis

      -10 + 12 sin 60 + Fₓ = 0

        Fₓ = 10- 12 sin 60 = -0.39 N

y-axis

       12 cos 60 - 6 + F_y = 0

        F_y = 6 - 12 cos 60 = 0 N

We can give the result of the force in two ways:

Let's use Pythagoras' theorem to find the modulus.

       [tex]F = \sqrt{F_x^2 + F_y^2 } \\F = \sqrt{0.39^2 +0^2}[/tex]  

       F = 0.39N

We use trigonometry for the angle.

       [tex]tan \theta = \frac{F_y}{F_x}[/tex]

       tan θ=  0º

The component of the force is negative therefore this angle is in the second quadrant, to measure the angle from the positive side of the x axis in a counterclockwise direction.

        θ = 180 + θ'

        θ = 180 + 0

        θ = 180º

C) if the three forces can be moved and the maximum force occurs when they are all linear.

          10+ 6 + 6 + F = 0

          F = -24 N

D) if we maintain this force and eliminate the other three, the block stops, let's look for its acceleration.

          [tex]a = \frac{F}{m}[/tex]  

          a = [tex]\frac{24}{6}[/tex]  

         a =  4 m / s²

The acceleration is in the opposite direction of the initial velocity of the block v₀ = -100 m / s

If we use kinematic relations.

        v = v₀ - a t

Final velocity when stopped is zero

         t = [tex]\frac{0-v_o}{a}[/tex]

         t = 100/4

         t = 25 s

In conclusion using Newton's second law and the kinematics relations we can find the results for the questions about the forces and the motion of the block are:

    B) the force applied to maintain the system is equilibrium is: F = 0.39 N with an angle of tea = 180º

    C) The maximum force is: F = 24 N

    D) The time to stop the block is: t = 25 s

Learn more about Newton's second law here: brainly.com/question/25545050

Answer:

Die Antwort lautet: Weniger Umweltverschmutzung als Kraftwerke mit fossilen Brennstoffen

Explanation:

hoffe das hat geholfen!! :))

Answer:

Changes to regional landscapes

Explanation:

It would be D because this is a cost or drawback and geothermal energy production would cause changes to the landscape, unlike how fossil fuels would.  I also got this right on the quiz.

Hope this helps!

Answer:

gravity

Explanation:

Even when satellites are thousands of miles away, Earth's gravity still tugs on them. Gravity—combined with the satellite's momentum from its launch into space—cause the satellite to go into orbit above Earth, instead of falling back down to the ground.

Answer:

This is the answer that I got

Explanation:

Hope it is right.

Answer:

54

Explanation:4

4

4

Answer:

30d

Explanation:

30d

Answer:

h = v 0 y 2 2 g . This equation defines the maximum height of a projectile above its launch position and it depends only on the vertical component of the initial velocity.

Explanation:

Answer:

[tex]momentum =mv \\ 50 = 5v \\ v = \frac{50}{5} \\ v= 10m. {s}^{ - 1} [/tex]

Answer:

You should try your best to answer the question.

Answer:

Jake’s horse will only need to exert enough force to make the carriage accelerate. Even though the carriage will pull on the horse as well, that force is not enough to make the horse accelerate in the direction of the carriage because it is only strong enough to make the carriage accelerate, not the horse.

Explanation:

Additional info: the horse has more mass than the carriage does so it would require a stronger force to make the horse accelerate.

Answer: Jake’s horse will only need to exert enough force to make the carriage accelerate .Since the horse has a greater mass than the carriage, it requires a stronger force to make the horse accelerate.

Explanation: Sorry it took so long lol

Answer:

wat

Explanation:

As the Moon orbits our planet, its varying position means that the Sun lights up different regions, creating the illusion that the Moon is changing shape over time. This is because it rotates once on its axis in exactly the same time it takes to orbit Earth – 27 days and seven hours

Answer:

A network has 5 basic components viz. clients, servers, channels, interface devices and operating systems.

Answer:

D

Explanation:

A is wrong as the direction of the car changes, implying velocity is changing and not constant.

B and C are wrong as both the change in speed and direction contribute to the change in velocity

Answer:

  4/3 m/s

Explanation:

Assuming momentum is conserved, the sum of products of mass and speed before the collision is the same as after:

  (2000 kg)(4 m/s) +(4000 kg)(0 m/s) = (2000 +4000 kg)(Vt)

  Vt = (8000 kg·m/s)/(6000 kg) = 4/3 m/s

The speed of the combined objects after the collision is 4/3 m/s.

Answer:

0.9m/s^2 (yours is 0.87, so choose that)

Explanation:

formula for centripetal acceleration:

v^2/r

to find v, we know that f=1/90s, and r=180m.

v=(2pir)/T

v=(2pi(180))/90

v=12.6m/s

now plug into a=v^2/r

a=(12.6)^2/180

a=0.9m/s^2

1. • Here, force of gravity on the block = 20 N.

• Therefore, the normal force will also be the same, i.e., 20 N [According to Newton's Third Law, on every action, there is an equal and opposite reaction]

• The coefficient

[tex] u_{k} = 0.4[/tex]

• Force of friction =

[tex]u_{k} \times \: normal \: \: \: force \\ = 0.4 \times 20N \\ = 8N[/tex]

• Hence, the force of sliding friction between the block and the ground is 8 N.

• So, it is option c. 8 N

2. The answer is option d. continue in the same direction with no change in speed.

We know, force = mass × acceleration. When force is 0, then acceleration will also be 0 since mass cannot be 0. So, there will be no change in speed.

3. It is option b. force that is required to give a one kilogram object the acceleration of 1 m/s^2.

Newton is the SI unit of force. As mentioned earlier, force = mass × acceleration. The SI unit of mass and acceleration is Kg and m/s^2 respectively.

So, 1 N = 1 Kg × 1 m/s^2.

4. It is d. not zero.

Acceleration is the change in speed. So, if the force is zero, then acceleration will not occur.

5. Force = 2 N

Acceleration of the object A = 2 m/s^2.

Acceleration of the object B = 1 m/s^2.

Therefore, mass of the object A = 2 N ÷ 2 m/s^2 = 1 Kg

And, mass of the object B = 2 N ÷ 1 m/s^2 = 2 Kg

So, the mass of object B is greater than that of object A.

Hence, the answer is option c. Object B has more mass.

Hope you could get an idea from here.

Doubt clarification - use comment section.

Answer:

A quick way of describing density is to describe an object as heavy or light for its size. Pumice stone, unlike regular rock, does not sink in water because it has a low density. An ironwood branch is very dense and sinks in water.

Hope that helps. x

Answer:

Pumice is trapped in gas when the temperature is warm, but as the temp drops, it becomes dense, due to air bubbles. Iron wood is denser than water, thus making it sink.

Explanation:

Answer:

This is the answer that I got.

Explanation:

Just check over it once.

Hi there!

We can begin by solving for the velocity in which the ball was thrown at using the following:

[tex]v_f^2 = v_i^2 + 2ad[/tex]

At the top of the trajectory, the ball's velocity is equal to 0 m/s, so:

[tex]0 = v_i^2 + 2ad\\\\vi^2 = 2ad \\\\[/tex]

'a' = acceleration due to gravity and 'd' is the max height, so:

[tex]v_i^2 = 2(10)(5)\\\\v_i^2 = 10 m/s[/tex]

Now, we can use the same equation to calculate the final speed at 4.5 m. Remember, the acceleration is NEGATIVE in this instance (taking the negative direction to be in the direction of gravity).

[tex]v_f^2 = 10^2 - 2(10)(4.5)[/tex]

[tex]v_f^2 = 10^2 - 2(10)(4.5)\\\\v_f^2 = 100 - 90 \\\\v_f^2 = 10 \\\\v_f = \boxed{3.1 m/s}[/tex]